Abstrak


Pengukuran faktor wedge pada pesawat teleterapi cobalt-60: Perkiraan dan pemodelan dengan software MCNPX


Oleh :
Ajeng Sarinda Yunia Putri - M02 - Fak. MIPA

PENGUKURAN FAKTOR WEDGE PADA PESAWAT TELETERAPI COBALT-60 : PERKIRAAN DAN PEMODELAN DENGAN SOFTWARE MCNPX

 

Ajeng Sarinda Yunia Putri1, Suharyana1, Muhtarom2

1Prodi Fisika , Universitas Sebelas Maret, Jl. Ir. Sutami No. 36A, Surakarta 57126

2Instalasi Radioterapi  RSUD Dr. Moewardi, l. Kolonel Sutarto No. 132 Surakarta

e-mail : ajeng.sarinda@student.uns.ac.id

 

ABSTRAK

Penelitian ini bertujuan untuk menentukan geometri wedge yang menghasilkan isodosis sudut 20° dan mengetahui nilai faktor transmisi wedge sudut 20°. Pada penelitian ini digunakan software Monte Carlo N-Particle eXtended Version (MCNPX) untuk menghitung laju dosis serap dari pesawat teleterapi  60Co. Sebelumnya dilakukan pengukuran faktor wedge sudut  30° dan 60°, hasil simulasi dibandingkan dengan hasil pengukuran langsung. Hasil simulasi memiliki kesalahan relatif 3,4 %  dan 2,3 % terhadap dengan hasil pengukuran langsung. Dapat dikatakan hasil simulasi mendekati hasil pengukuran langsung, kemudian dilakukan simulasi untuk menentukan geometri wedge yang menghasilkan isodosis sudut 20°. Setelah dilakukan simulasi didapatkan geometri wedge yang menghasilkan isodosis sudut 20° yaitu panjangnya  panjangnya 16 cm, lebarnya 15,3 cm, tebalnya 0,83 cm, nilai sudut θ sebesar 3,1°. Faktor wedge sudut 20° sebesar 0,671.

 

 Kata kunci : MCNPX, Faktor  wedge, isodosis

 

 

ABSTRACT

This research purpose to determine the wedge geometry that produces 20 ° angular isodosis and to know the value of wedge angle 20 °. In this study used Monte Carlo N-Particle eXtended Version (MCNPX) software to calculate the absorbed dose rate of the 60Co teletherapy machine. Previously measured angle wedge factor 30 ° and 60 °, the simulation results compared with the results of experiment. The simulation result has a relative error of 3.4% and 2.3% against with the result of experiment. It can be said that the simulation result approaches the direct experiment, then simulation to determine the wedge geometry that produces 20 ° angle isodosis. After the simulation, the wedge geometry was obtained which resulted in 20 ° angular is of 16 cm in length, 15.3 cm in width, 0.83 cm thick, θ of 3.1 °. Wedge factor of 20 ° angle is 0.671.

 

Keywords : MCNPX, wedge factor, isodose